Near Fort Selden at the head of the Mesilla Valley
Epoxy Flooring in Radium Springs, NM
Garage, shop and patio coatings for the upper valley, where a slab can see triple-digit summers and hard winter freezes.
- Free on-site estimates with the slab measured and inspected
- Itemized written quote naming every prep step and coat
- Diamond-ground concrete and filled cracks under every coating
Coatings for the Top of the Valley
Epoxy flooring in Radium Springs has to handle a wider temperature range than most people expect from the desert. The climate table on Wikipedia, built from 1991 to 2020 normals at the Jornada Experimental Range station, shows June highs averaging 95.8°F. The same records list an all-time low of -20°F, reached in 1948 and again in February 2011. A garage or shop floor here goes from baking to freezing over the year, and the coating we pick has to stay bonded through both.
Why the swing matters for a coating
Concrete grows and shrinks a little with temperature. A rigid, thin coating on a poorly prepped slab can lift at the edges or crack along old joints when that movement repeats every season. Our answer is simple:
- Grind the whole slab so the resin soaks into open concrete
- Fill and flex-seal cracks and control joints before the base coat
- Use a polyaspartic topcoat on floors that get sun through an open door, since it holds up to UV and handles a wide temperature range
- Schedule summer installs for the early morning and winter installs for the warmest part of the day
Old ground, newer homes
This is one of the oldest corners of the valley. Fort Selden, an adobe Army post set up in 1865 near today's Radium Springs, guarded settlers and travelers until it was abandoned for good in 1891. Nearby, Leasburg Dam was finished in 1908 to send Rio Grande water into canals for Mesilla Valley farms. The homes you see here now are much newer than either. The CDP counted 689 housing units in 2010 spread over about 6 square miles, which works out to roughly 115 per square mile. That spacing leaves room for detached garages, metal shops and RV covers next to the house.
What we coat most often around here
- Detached shops and pole barns: a thicker commercial-grade epoxy that stands up to jacks, welding sparks and dropped tools
- Attached garages: a flake system that hides the fine grit the upper valley wind carries in
- Patios and covered porches: a textured, light-colored coating that stays cooler underfoot
- Cracked slabs: repair work first, so the coating is not hiding a problem
Rain comes all at once
Radium Springs averages about 10.44 inches of precipitation a year, and July and August bring more than 4 inches of that between them. Monsoon storms can push water and mud under a garage door in a few minutes. A sealed floor wipes clean, and a fine non-slip grit in the topcoat helps near the door where it gets wet. We can also add a cove base along the walls of a shop so washwater stays on the coated floor.
Who lives here
The 2010 census profile shows a settled community. The median age was 41, and about 32% of residents were between 45 and 64. Many owners here have had the same property for years and are now finishing the shop or garage they always meant to fix up. We give you a written scope that spells out the prep, the coats and the cure times, so you can plan the job around your own work.
Radium Springs Facts That Shape the Job
- Big temperature range. Records at the Jornada Experimental Range station include a high of 110°F (1951 and 1980) and a low of -20°F (1948 and 2011), with June highs averaging 95.8°F.
- Monsoon-heavy rainfall. Of about 10.44 inches of yearly precipitation, July averages 2.24 inches and August 2.03 inches, while March averages only 0.24 inches.
- Fort Selden history. The U.S. Army built the adobe Fort Selden near Radium Springs in 1865; it was abandoned in 1891 and became a New Mexico State Monument in 1974.
- Room to spread out. The 2010 census counted 689 housing units across about 6 square miles, an average of 115 units per square mile, with 635 households.

Radium Springs Questions
Can you coat a metal shop floor in Radium Springs?
Yes. Shop slabs are often rougher and dirtier than garage floors, so we spend more time grinding, degreasing and filling. We then use a thicker 100% solids epoxy system that handles jacks, tools and spills. If you weld in the shop, tell us so we can choose a topcoat that resists sparks and hot slag.
Will a garage coating hold up when it freezes here?
A well-bonded coating on ground concrete handles freezing nights fine. The bigger risk is installing in the cold, so in winter we check slab temperature before we start and only coat during the warmest hours of the day.
How long will my Radium Springs garage be out of use?
Most garages are walkable within a day and ready for cars in a few more days, depending on the system and the weather. Polyaspartic topcoats shorten that window. You get the exact timing in writing when we finish.
Free Estimates in Radium Springs, NM
Free on-site estimates for garages, shops and patios in Radium Springs.
Epoxy Flooring Near Radium Springs
- Epoxy Flooring in Las Cruces, NM
- Epoxy Flooring in Mesilla, NM
- Epoxy Flooring in University Park, NM
- Epoxy Flooring in Doña Ana, NM
- Epoxy Flooring in Organ, NM
- Epoxy Flooring in Butterfield Park, NM
- Epoxy Flooring in Fairacres, NM
- Epoxy Flooring in San Ysidro, NM
- Epoxy Flooring in White Sands, NM
- Epoxy Flooring in Mesquite, NM
- Epoxy Flooring in Vado, NM
- Epoxy Flooring in La Mesa, NM
- Epoxy Flooring in Chamberino, NM
- Epoxy Flooring in Berino, NM
- Epoxy Flooring in Anthony, NM
- Epoxy Flooring in Vinton, TX
- Epoxy Flooring in Canutillo, TX
- Epoxy Flooring in Santa Teresa, NM