Epoxy Flooring in San Ysidro, NM

Epoxy flooring in San Ysidro usually starts with a family garage that does more than park a car. San Ysidro is a census-designated place in Doña Ana County covering about 2.6 square miles of the valley floor. It had 2,090 residents in 2010, about 790 people per square mile. That is a lot of households in a small area, and the garage often doubles as storage, a workout corner, a laundry space or a spot for the kids to work on projects.

A floor that takes daily use

A garage that gets used every day collects scuffs, spills and grit fast. Bare concrete soaks up oil and paint, and it sheds dust that ends up tracked into the house. A coated floor seals that surface. For most San Ysidro homes we suggest one of two systems:

• Full-broadcast flake: color chips cover the whole base coat, then a clear topcoat locks them in. The speckled look hides dust and small marks between cleanings.
• Solid color with a polyaspartic topcoat: a cleaner look for a garage gym or workspace, with a topcoat that resists yellowing in sunlight.

Both go down over a diamond-ground slab, never over bare troweled concrete.

Valley floor concrete

San Ysidro sits at about 3,918 feet, down in the Rio Grande valley rather than up on the mesa. Valley floors have their own soil and water conditions, and slabs here can show hairline shrinkage cracks, settled corners or old patches from past repairs. We check each crack with a straightedge and a moisture test before we quote. Stable cracks get filled with a rigid repair material and ground flush. If a crack is still moving or water is coming up through the slab, we tell you before any coating goes down, because a coating will not fix either one.

Get a Free Estimate

Patios and back slabs

Many valley homes have a back patio or a side slab where the family spends evenings. Bare outdoor concrete gets hot in direct sun and stains easily from grills and planters. A textured, light-colored coating keeps the surface easier to clean and adds grip for wet feet. We pick colors that do not soak up as much heat, and we finish with a UV-stable topcoat so the patio does not chalk or yellow.

What an estimate looks like

• We come out, measure the floor and look at every crack and stain
• We test for moisture and check for old paint or sealer
• You get a written quote listing the system, coats, prep and total
• We set an install date and tell you what to clear out of the garage

You do not pay for anything until you have seen the written scope.

Matching the system to the room

A garage that is mostly for parking needs a different floor than one used as a gym or a hobby room. For parking, we focus on hot-tire resistance at the wheel paths, because bare tires coming in off summer pavement can lift weak coatings. For a gym, we suggest a solid color base with a light flake and a matte topcoat that is easy on bare feet and rubber mats. For a hobby or craft space, a lighter color brightens the room and makes small dropped parts easier to find. Tell us how you use the space and we will build the quote around it.

Timing an install around the weather

Summer afternoons on the valley floor are hot, and resin cures faster as temperature climbs. We start early, keep the door closed when we can and work in smaller sections so each coat goes down evenly. In the cooler months we check the slab temperature before we begin. If a storm is coming in, we may move the topcoat to the next morning rather than risk dust or moisture getting into it.